| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Reachable Assertion (CWE-617) in Elasticsearch can lead to denial of service via Input Data Manipulation (CAPEC-153). A specially crafted search request containing a null value in a specific query clause causes an internal assertion to be raised during query parsing. Because Elasticsearch treats assertion failures as fatal errors, this terminates the affected node process. A low-privileged authenticated user with read access to at least one index can exploit this condition with a single request to cause a node to terminate, disrupting search availability. In a single-node deployment this fully stops Elasticsearch; in a multi-node cluster it reduces cluster capacity for each affected node. |
| The NXP LPUART serial driver (drivers/serial/uart_mcux_lpuart.c), when CONFIG_UART_USE_RUNTIME_CONFIGURE is enabled, called LPUART_Deinit() at the start of mcux_lpuart_configure(), which disables the LPUART peripheral clocks. The requested configuration is validated only afterwards (in mcux_lpuart_configure_basic), and unsupported parity/data-bit/stop-bit/flow-control values return -ENOTSUP before the clock is re-enabled.
As a result, a uart_configure() request with an unsupported configuration left the LPUART in a clock-disabled state; any subsequent access to LPUART registers (poll_out/poll_in, interrupt handling, or a later reconfigure) faults on the gated peripheral and escalates to a hard fault, crashing the system.
uart_configure() is a Zephyr syscall whose verifier (z_vrfy_uart_configure) only checks that cfg is readable user memory and forwards the caller-supplied configuration unchanged, so an unprivileged userspace thread with access to an LPUART device can deterministically trigger the fault, a persistent system-wide denial of service.
Introduced in v2.5.0 and present in all subsequent releases until this fix, which removes the LPUART_Deinit() call and instead only disables the transmitter/receiver, leaving the clock running. |
| bt_sdp_parse_attribute() in subsys/bluetooth/host/classic/sdp.c validated only that the SDP record buffer held the type-marker byte plus the 2-byte attribute ID (a check of buf->len < 3) but then read a fourth byte, the data-element descriptor (type), via net_buf_simple_pull_u8(). Because net_buf_simple_pull_u8() dereferences buf->data[0] before its only bounds guard (an __ASSERT_NO_MSG that compiles out when CONFIG_ASSERT is disabled, the production default), a record of exactly three bytes (0x09 followed by a 2-byte attribute ID) causes a one-byte read past the end of the logical buffer. The parser is reachable from inbound, remote-controlled data: a Bluetooth BR/EDR peer acting as an SDP server returns discovery-response records that are stored verbatim in the client receive buffer and parsed via the public bt_sdp_get_attr()/bt_sdp_has_attr()/bt_sdp_record_parse() helpers. The over-read is bounded to a single byte that is used only as an internal length selector and is never leaked to the attacker; subsequent length checks then reject the malformed record. Realistic impact is therefore limited to an edge-case denial of service (a fault only if the record ends exactly at a mapped-memory boundary, or a deterministic assert panic when CONFIG_ASSERT=y). Affects Zephyr v4.3.0 and v4.4.0; fixed by adding sizeof(type) to the length check. |
| Quicly is an IETF QUIC protocol implementation intended primarily for use within the H2O HTTP server. Prior to commit 937d0e9, an assertion failure is raised when the total number of valid handshake messages received over a CRYPTO stream of a single packet number space exceeds 32KB, causing a Denial of Service. This issue has been fixed by commit 937d0e9. |
| An invalidly formatted IKEv2 fragment causes the Libreswan pluto daemon to crash and restart. Continued exploitation would cause a denial of service. The function reassemble_v2_incoming_fragments() would ignore unknown outer payloads but still store these in a fixed size array msg_digest.digest[PAYLIMIT]. An off-by-one error in the assertion PASSERT(logger, md->digest_roof < elemsof(md->digest)) causes the daemon to abort. No remote code execution is possible. Any configuration that allows IKEv2 connections that do not set fragmentation=no are vulnerable. IKEv1 is not affected. |
| Libreswan, via the function RSA_authenticate_hash_signature_pkcs1_1_5_rsa(), did not correctly verify the DER encoding of the ASN.1 digest when the IKEv2 AUTH payload was encoded using RSASSA-PKCS1-v1_5 (RFC 8017). A remote attacker can use a variation on the Bleichenbacher attack to forge the AUTH payload when small public exponents are used (e.g., e=3), leading to impersonation. Additionally, a remote attacker, by encoding a shorter than expected hash in the AUTH payload, could trigger an assertion leading to denial-of-service. The daemon aborts and restarts; continued exploitation causes sustained denial of service. Remote code execution is not possible. X.509 certificate verifications of the remote IKE peer are not affected. |
| Libreswan, via the function RSA_authenticate_hash_signature_raw_rsa(), did not correctly verify the length of the authentication hash when the SIG payload of an IKEv1 packet was encoded using PKCS #1 RSA Encryption as per RFC 2313. A remote attacker can use a variation on the Bleichenbacher attack to forge the SIG payload when small public exponents are being used (e.g., e=3), which could lead to impersonation. Additionally, a remote attacker, by encoding a shorter than expected hash in the SIG payload, could trigger an assertion leading to denial-of-service. The daemon aborts and restarts; continued exploitation causes sustained denial of service. Remote code execution is not possible. X.509 certificate verifications of remote IKE peers are not affected. |
| TLS ECH decryptor crash in Wireshark 4.6.0 to 4.6.6 allows denial of service |
| OpenVPN version 2.6.0 through 2.6.20 and 2.7_alpha1 through 2.7.4 allows remote attackers to cause a denial of service via a malformed authentication token that triggers a reachable assertion when external-auth is enabled |
| vLLM is a library for LLM inference and serving. From 0.12.0 to before 0.24.0, sending a pure prompt embeds payload in a /v1/completions request with a model using M-RoPE causes EngineCore to fail an assertion and fatally crash, shutting down the entire server application. Any remote user who is authorized to make a /v1/completions request can make such a request and induce a crash. This issue is fixed in version 0.24.0. |
| In the Linux kernel, the following vulnerability has been resolved:
blk-wbt: remove WARN_ON_ONCE from wbt_init_enable_default()
wbt_init_enable_default() uses WARN_ON_ONCE to check for failures from
wbt_alloc() and wbt_init(). However, both are expected failure paths:
- wbt_alloc() can return NULL under memory pressure (-ENOMEM)
- wbt_init() can fail with -EBUSY if wbt is already registered
syzbot triggers this by injecting memory allocation failures during MTD
partition creation via ioctl(BLKPG), causing a spurious warning.
wbt_init_enable_default() is a best-effort initialization called from
blk_register_queue() with a void return type. Failure simply means the
disk operates without writeback throttling, which is harmless.
Replace WARN_ON_ONCE with plain if-checks, consistent with how
wbt_set_lat() in the same file already handles these failures. Add a
pr_warn() for the wbt_init() failure to retain diagnostic information
without triggering a full stack trace. |
| In the Linux kernel, the following vulnerability has been resolved:
iommu: Fix WARN_ON in __iommu_group_set_domain_nofail() due to reset
In __iommu_group_set_domain_internal(), concurrent domain attachments are
rejected when any device in the group is recovering. This is necessary to
fence concurrent attachments to a multi-device group where devices might
share the same RID due to PCI DMA alias quirks, but triggers the WARN_ON in
__iommu_group_set_domain_nofail().
Other IOMMU_SET_DOMAIN_MUST_SUCCEED callers in detach/teardown paths, such
as __iommu_group_set_core_domain and __iommu_release_dma_ownership, should
not be rejected, as the domain would be freed anyway in these nofail paths
while group->domain is still pointing to it. So pci_dev_reset_iommu_done()
could trigger a UAF when re-attaching group->domain.
Honor the IOMMU_SET_DOMAIN_MUST_SUCCEED flag, allowing the callers through
the group->recovery_cnt fence, so as to update the group->domain pointer.
Instead add a gdev->blocked check in the device iteration loop, to prevent
any concurrent per-device detachment. |
| In the Linux kernel, the following vulnerability has been resolved:
accel/ethosu: reject NPU_OP_RESIZE commands from userspace
NPU_OP_RESIZE is a U85-only command that the driver does not yet
implement. The existing WARN_ON(1) placeholder fires unconditionally
whenever userspace submits this command via DRM_IOCTL_ETHOSU_GEM_CREATE,
causing unbounded kernel log spam.
If panic_on_warn is set the kernel panics, giving any unprivileged user
with access to the DRM device a trivial denial-of-service primitive.
Replace the WARN_ON(1) with an explicit -EINVAL return so the ioctl
rejects the command before it reaches hardware. |
| In EmberZNet v9.0.2 and earlier, malformed Color Control messages can lead to asserts that terminate the process. These messages must come from a device that has already joined the network. Only devices supporting the Color Control cluster may be impacted. |
| In EmberZNet v9.0.2 and earlier, malformed Color Control messages can lead to asserts that terminate the process. These messages must come from a device that has already joined the network. Only devices supporting the Color Control cluster may be impacted. |
| CWE-617 Reachable Assertion vulnerability exists that could allow an authenticated attacker to trigger a denial-of-service condition, impacting system availability when a specially crafted request is sent to a vulnerable network-exposed service. |
| NSD from version 4.13.0 has a heap use-after-free bug in logging errors on TLS connections, causing a crash of the server process, which can be triggered trivially by sending a DNS query over a DoT connection, and closing the connection without reading the response. |
| In the Linux kernel, the following vulnerability has been resolved:
ocfs2: validate group add input before caching
[BUG]
OCFS2_IOC_GROUP_ADD can trigger a BUG_ON in
ocfs2_set_new_buffer_uptodate():
kernel BUG at fs/ocfs2/uptodate.c:509!
Oops: invalid opcode: 0000 [#1] SMP KASAN NOPTI
RIP: 0010:ocfs2_set_new_buffer_uptodate+0x194/0x1e0 fs/ocfs2/uptodate.c:509
Code: ffffe88f 42b9fe4c 89e64889 dfe8b4df
Call Trace:
ocfs2_group_add+0x3f1/0x1510 fs/ocfs2/resize.c:507
ocfs2_ioctl+0x309/0x6e0 fs/ocfs2/ioctl.c:887
vfs_ioctl fs/ioctl.c:51 [inline]
__do_sys_ioctl fs/ioctl.c:597 [inline]
__se_sys_ioctl fs/ioctl.c:583 [inline]
__x64_sys_ioctl+0x197/0x1e0 fs/ioctl.c:583
x64_sys_call+0x1144/0x26a0 arch/x86/include/generated/asm/syscalls_64.h:17
do_syscall_x64 arch/x86/entry/syscall_64.c:63 [inline]
do_syscall_64+0x93/0xf80 arch/x86/entry/syscall_64.c:94
entry_SYSCALL_64_after_hwframe+0x76/0x7e
RIP: 0033:0x7bbfb55a966d
[CAUSE]
ocfs2_group_add() calls ocfs2_set_new_buffer_uptodate() on a
user-controlled group block before ocfs2_verify_group_and_input()
validates that block number. That helper is only valid for newly
allocated metadata and asserts that the block is not already present in
the chosen metadata cache. The code also uses INODE_CACHE(inode) even
though the group descriptor belongs to main_bm_inode and later journal
accesses use that cache context instead.
[FIX]
Validate the on-disk group descriptor before caching it, then add it to
the metadata cache tracked by INODE_CACHE(main_bm_inode). Keep the
validation failure path separate from the later cleanup path so we only
remove the buffer from that cache after it has actually been inserted.
This keeps the group buffer lifetime consistent across validation,
journaling, and cleanup. |
| In the Linux kernel, the following vulnerability has been resolved:
libceph: replace overzealous BUG_ON in osdmap_apply_incremental()
If the osdmap is (maliciously) corrupted such that the incremental
osdmap epoch is different from what is expected, there is no need to
BUG. Instead, just declare the incremental osdmap to be invalid. |
| The $_internalConvertBucketIndexStats stage used PauseExecution as a way to signal "skip this document" when an index stats conversion failed. But PauseExecution is not a general purpose skip mechanism, but rather a TeeBuffer-internal signal used solely by $facet to coordinate its sub-pipelines. When this stage is placed before $facet in a pipeline, TeeBuffer receives the unexpected PauseExecution from upstream and hits a hard invariant assertion, crashing mongod. |
