| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a local attacker to gain elevated privileges due to a heap buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a local attacker to execute arbitrary code due to a stack-based buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a local attacker to execute arbitrary code due to a heap-based buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a local attacker to execute arbitrary code due to a buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a local attacker to gain elevated privileges due to a heap-based buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to execute arbitrary code due to a heap buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to execute arbitrary code due to a heap buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a local attacker to cause a denial of service due to a heap buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to execute arbitrary code due to a stack buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote authenticated attacker to obtain sensitive information and cause a denial of service due to an out-of-bounds write. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to execute arbitrary code due to an out-of-bounds write. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to execute arbitrary code due to a stack buffer overflow. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to execute arbitrary code due to a stack buffer overflow. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_set_pipapo: don't leak bad clone into future transaction
On memory allocation failure the cloned nft_pipapo_match can enter a bad
state:
- some fields can have their lookup tables resized while others did
not
- bits might have been toggled
- scratch map can be undersized which also means m->bsize_max can be
lower than what is required
This means that the next insertion in the same batch can trigger
out-of-bounds writes.
Furthermore, a failure in the first can result in the bad clone to
leak into the next transaction because the abort callback is never
executed in this case (the upper layer saw an error and no attempt to
allocate a transactional request was made).
Record a state for the nft_pipapo_match structure:
- NEW (pristine clone)
- MOD (modified clone with good state)
- ERR (potentially bogus content)
Then make it so that deletes and insertions fail when the clone
entered ERR state.
In case the very first insert attempt results in an error, free the
clone right away. |
| In the Linux kernel, the following vulnerability has been resolved:
ata: libata-core: Reject an invalid concurrent positioning ranges count
ata_dev_config_cpr() takes the number of range descriptors from buf[0]
of the concurrent positioning ranges log (up to 255), which the device
reports independently of the log size in the GPL directory. The count is
then walked at a fixed 32-byte stride in two places with no bound: the
log read here, and the INQUIRY VPD page B9h emitter, which writes one
descriptor per range into the fixed 2048-byte ata_scsi_rbuf. A device
reporting a count larger than its own log overflows the read buffer (up
to 7704 bytes past a 512-byte slab), and a count above 62 overflows the
response buffer on the emit side.
Bound the count once, on probe, against both the log the device returned
and the number of descriptors the VPD B9h response buffer can hold
(ATA_DEV_MAX_CPR, derived from the rbuf size). Reject an out-of-range
count with a warning; this keeps the emitter in bounds with no separate
change there. |
| In the Linux kernel, the following vulnerability has been resolved:
Input: mms114 - reject an oversized device packet size
mms114_interrupt() reads a packet of touch data from the device into a
fixed-size on-stack buffer
struct mms114_touch touch[MMS114_MAX_TOUCH];
which holds MMS114_MAX_TOUCH (10) events of MMS114_EVENT_SIZE (8) bytes,
i.e. 80 bytes. The length of the I2C read into it is taken verbatim from
the device:
packet_size = mms114_read_reg(data, MMS114_PACKET_SIZE);
if (packet_size <= 0)
goto out;
...
error = __mms114_read_reg(data, MMS114_INFORMATION, packet_size,
(u8 *)touch);
packet_size is a single device register byte (0x0F) and the only check
is the lower bound packet_size <= 0; it is never bounded against the
size of touch[]. A malfunctioning, malicious or counterfeit controller
(or an attacker tampering with the I2C bus) can report a packet_size of
up to 255, so __mms114_read_reg() writes up to 175 bytes past the end of
touch[] on the IRQ-thread stack: a stack out-of-bounds write that can
overwrite the stack canary, saved registers and the return address.
A well-formed device never reports more than the buffer holds, so reject
an oversized packet and drop the report, consistent with the handler's
other error paths, rather than reading past the buffer. |
| In the Linux kernel, the following vulnerability has been resolved:
net/sched: act_pedit: fix TOCTOU heap OOB write in tc offload
There is a TOCTOU race condition in flower lockless approach between sizing
a flow_rule buffer and filling it.
zdi-disclosures@trendmicro.com reports:
The cls_flower classifier operates with TCF_PROTO_OPS_DOIT_UNLOCKED
(fl_change runs without RTNL), while RTM_NEWACTION holds RTNL, so the
independent locking domains make the race reachable in practice. KASAN
confirms:
BUG: KASAN: slab-out-of-bounds in tcf_pedit_offload_act_setup+0x81b/0x930
Write of size 4 at addr ffff888001f27520 by task poc-toctou/312
The buggy address is located 0 bytes to the right of
allocated 288-byte region [ffff888001f27400, ffff888001f27520)
(cache kmalloc-512)
Note: The result is a heap OOB write attacker-controlled content into the
adjacent slab object (requires CAP_NET_ADMIN).
The fix introduces reading tcfp_nkeys under act->tcfa_lock in all places
using a new tcf_pedit_nkeys_locked() which replaces the old tcf_pedit_nkeys().
Additionally we close the remaining TOCTOU window between the sizing read and
the fill reads by more careful accounting.
Rather than silently truncating the key count, which leads to incorrect
action semantics offloaded to hardware and secondary OOB writes if
the remaining capacity is zero or consumed by prior actions, we enforce
remaining capacity checks and return -ENOSPC if the required space exceeds
the remaining capacity. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix effective prog array index with BPF_F_PREORDER
replace_effective_prog() and purge_effective_progs() located the slot in
the effective array by walking the program hlist and counting entries
linearly. That count does not match the array layout: compute_effective_
progs() places BPF_F_PREORDER programs at the front (ancestor cgroup
first, attach order within a cgroup) and the rest after them (descendant
cgroup first). So when a preorder program is present, the linear hlist
position no longer equals the program's index in the effective array.
For replace_effective_prog() (bpf_link_update()) this overwrote the
wrong slot, corrupting the effective order. For purge_effective_progs(),
it could dummy out a slot belonging to a different program and leave the
detached program in the array while bpf_prog_put() drops its reference,
i.e. a use-after-free.
Fix both by replaying compute_effective_progs()'s placement (including
the per-cgroup preorder reversal) in a shared effective_prog_pos()
helper. Identify the entry by its struct bpf_prog_list pointer rather
than by (prog, link) value, so the lookup resolves to exactly the
attachment the syscall selected even when the same bpf_prog is attached
to several cgroups in the hierarchy. |
| In the Linux kernel, the following vulnerability has been resolved:
riscv: mm: Fix out-of-bounds page-table walk during memory hot-remove
remove_pud_mapping() and remove_p4d_mapping() obtain a child table base
with pud_offset(p4dp, 0) and p4d_offset(pgd, 0), then add the index for
addr.
RISC-V folds page-table levels at runtime. When a level is folded, its
offset helper returns the parent entry itself, but the index can still be
nonzero. Adding it walks past the parent table. Sv48 folds P4D, while Sv39
folds both P4D and PUD, so memory hot-remove can descend into unrelated
memory and pass an invalid page to __free_pages(). This can trigger:
kernel BUG at include/linux/mm.h:1810!
VM_BUG_ON_PAGE(page_ref_count(page) == 0)
arch_remove_memory+0x1e/0x5c
try_remove_memory+0x15e/0x200
remove_memory+0x24/0x3c
Only add the index when the corresponding page-table level is enabled,
matching p4d_offset() and pud_offset(). |
| In the Linux kernel, the following vulnerability has been resolved:
power: supply: core: fix supplied_from allocations
If dts property power-supplies has multiple values, then accessing to
psy->supplied_from[i-1] in __power_supply_populate_supplied_from will
overrun supplied_from array. |
