| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| The Goodix GT9xx input driver in drivers/input/input_gt911.c reads the touch point count from the controller's status register and masks it with GT911_TOUCH_POINTS_MSK (0x0F), yielding a value of 0..15. In gt911_process() that value is used directly as the loop bound for filling point_reg[], a stack array sized to CONFIG_INPUT_GT911_MAX_TOUCH_POINTS, whose Kconfig range is 1..5 with a default of 1. No other check constrains the count; the driver relied only on a comment asserting that the controller had been programmed at init to report no more points than configured.
Each loop iteration issues an I2C read of eight bytes straight into point_reg[i], so a controller that reports more points than the array holds causes up to 112 bytes of peer-supplied data to be written past the end of the array, over the stack frame of gt911_process() in the system workqueue thread. Two further loops then read out of bounds from the same array. Triggering it requires control of, or the ability to substitute, the I2C touch controller — plausible on the many supported boards where the GT9xx panel is a pluggable display module or shield rather than an on-PCB part; a spoofed device need only answer the init probes with a supported product ID and a checksum-valid config blob. The same overflow can also occur non-adversarially, with a GT9271-class panel that ignores the driver's touch-count programming and reports up to ten points, or with bus corruption of the single status byte.
The impact is an out-of-bounds stack write with fully attacker-chosen content executing at kernel privilege, i.e. potential control-flow hijack on the host MCU, in addition to out-of-bounds reads and crashes. The attack vector is physical/local hardware access only; there is no network, USB, or syscall path to the defect. The fix clamps the reported count with min() against CONFIG_INPUT_GT911_MAX_TOUCH_POINTS before any array indexing. |
| SoX through 14.4.2 contains a heap out-of-bounds write vulnerability in lsx_ms_adpcm_block_expand_i() in src/adpcm.c, triggered by an odd samplesPerBlock value in the WAV fmt chunk. Attackers can supply a crafted MS ADPCM WAV file to sox or any libsox consumer to write a partially controlled 16-bit sample past the heap buffer allocated by wav_ms_adpcm_fmt(). |
| libsmi through 0.5.0 contains an out-of-bounds write vulnerability in smiValueAsString() in lib/smi.c that allows attackers to overflow a fixed 1024-byte static buffer through hex rendering of OCTET STRING values. Attackers can supply a crafted MIB with an OCTET STRING DEFVAL of 512 or more octets and a leading 0x00 byte to corrupt adjacent library globals and crash smidump or other consumers. |
| NXP MQX Classic before 5.0 contains an out-of-bounds write vulnerability in the RTCS UDP recvfrom() implementation. Improper enforcement of the application-supplied receive buffer length may allow a crafted UDP packet to overflow the destination buffer, resulting in memory corruption, or denial of service. |
| Godot Engine through 4.7.2 has a heap out-of-bounds write in the Radiance HDR (.hdr) image decoder (modules/hdr/image_loader_hdr.cpp). The run-length decoding loop expands RLE instructions read from the file into a buffer sized from the image dimensions, without validating that an instruction's repeat/copy count fits the remaining capacity of the row buffer. A crafted .hdr file therefore writes attacker-supplied bytes past the end of the heap allocation, with the overflow length and content controlled by the file. The defect is reached automatically when the product imports a crafted .hdr (e.g., when opening a project containing one), and at runtime in exported projects that load untrusted .hdr images. NOTE: the Supplier's position is that the research has identified "no security issues" because the required attacker access is outside of the current Godot Engine threat model. |
| libTiMidity through 0.2.8 contains a stack out-of-bounds write vulnerability in the SoundFont loader that allows attackers to corrupt stack memory via unchecked generator operators in parse_gen. Attackers can supply a crafted .sf2 file with out-of-range pgen/igen operator values to write chosen 16-bit values near the stack Layer object, causing crashes and stack memory corruption. |
| AdPlug through 2.4 contains a heap-based buffer overflow in CksmPlayer::update() in src/ksm.cpp that writes past the fixed databuf[2048] array without bounds checking. Attackers can supply a crafted .ksm module whose notes share one time slot to overflow the heap player object, causing memory corruption and denial of service. |
| Substance3D - Designer is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| An issue was discovered in JasPer 1.900.8, 1.900.9, 1.900.10, 1.900.11, 1.900.12, 1.900.13, 1.900.14, 1.900.15, 1.900.16, 1.900.17, 1.900.18, 1.900.19, 1.900.20, 1.900.21, 1.900.22, 1.900.23, 1.900.24, 1.900.25, 1.900.26, 1.900.27, 1.900.28, 1.900.29, 1.900.30, 1.900.31, 2.0.0, 2.0.1, 2.0.2, 2.0.3, 2.0.4, 2.0.5, 2.0.6, 2.0.7, 2.0.8, 2.0.9, 2.0.10, 2.0.11, 2.0.12, 2.0.13, 2.0.14, 2.0.15, 2.0.16. There is a heap-based buffer overflow of size 1 in the function jas_icctxtdesc_input in libjasper/base/jas_icc.c. |
| In all versions of Node.js prior to 6.14.4, 8.11.4 and 10.9.0 when used with UCS-2 encoding (recognized by Node.js under the names `'ucs2'`, `'ucs-2'`, `'utf16le'` and `'utf-16le'`), `Buffer#write()` can be abused to write outside of the bounds of a single `Buffer`. Writes that start from the second-to-last position of a buffer cause a miscalculation of the maximum length of the input bytes to be written. |
| Microsoft Office 2007 SP2, Microsoft Office Word Viewer, Microsoft Office 2010 SP2, Microsoft Office 2013 SP1 and RT SP1, Microsoft Office 2016, and Microsoft Office 2016 Click-to-Run (C2R) allow a remote code execution vulnerability, due to how Office handles objects in memory, aka "Microsoft Office Memory Corruption Vulnerability". This CVE is unique from CVE-2018-0852. |
| A buffer overflow vulnerability in HPE NonStop RDMA SERVICES NSK may cause out-of-bounds memory write, which may result in memory corruption. |
| Out-of-bounds write vulnerability in Citrix Workspace app for Windows.
This issue affects Workspace app for Windows: before 2603.20 CR, before LTSR 2607 Hotfix 1, and before LTSR 2507 CU3 Hotfix 1. |
| When the PCM sample array needs to grow, the RACK stack doubles a 16-bit allocation counter. Repeated doublings caused the counter to wrap to zero, resulting in a near-zero-length allocation followed by a copy of the existing samples into the undersized buffer. A remote peer can trigger the expansion by sending a sufficient number of ACKs on an established connection.
A remote attacker who can establish a TCP connection to a system using the RACK stack can trigger an out-of-bounds write of approximately 512 KB in the kernel heap possibly resulting in a kernel panic. |
| A flaw was found in Ghostscript. When Ghostscript renders a crafted PostScript or EPS document, it can bypass the -dSAFER sandbox and execute arbitrary shell commands in the context of the Ghostscript process. The issue chains memory corruption in document parsing with disabling of internal path access controls at runtime. An attacker can deliver the document directly or through formats that delegate rendering to Ghostscript (for example EPS import or print conversion workflows). Successful exploitation can compromise confidentiality, integrity, and availability of data accessible to the process running Ghostscript. |
| A flaw was found in DPDK lib/vhost vhost-crypto. Integer overflow in chain length checks, and missing length checks on the RSA path, can overflow a host buffer in the vhost-crypto backend. |
| A flaw was found in DPDK lib/vhost vhost-crypto. A guest can supply an avail-ring descriptor index that is used without bounds checking, causing an out-of-bounds write in the host vhost-crypto backend. |
| A flaw was found in DPDK lib/vhost. A guest can desynchronize virtqueue size from inflight descriptor table size, causing an out-of-bounds write in the host vhost process. |
| FreeRDP 3.3.0 before 3.32.0, when built with WINPR_UTILS_IMAGE_JPEG=ON, has a heap-based out-of-bounds write in winpr_convert_from_jpeg because grayscale JPEG buffers are sized from one input component rather than three BGR output components. A malicious RDP server can offer a grayscale JPEG via clipboard redirection, corrupting client memory and crashing it when the item is pasted as CF_DIB bitmap data. |
| A vulnerability has been found in GPAC up to 26.07.0. This vulnerability affects the function gf_m2ts_decode_ait of the file src/media_tools/ait.c of the component AIT Parser. Such manipulation leads to out-of-bounds write. The attack may be launched remotely. The exploit has been disclosed to the public and may be used. The name of the patch is 6d2c21a1a688abb20d0111b608db3b6f44d348f4. Applying a patch is advised to resolve this issue. |
