| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: Fix NULL tty_dev dereference in rfcomm_dev_shutdown
syzbot hit a NULL pointer dereference in rfcomm_dev_shutdown() when an
RFCOMM tty is closed.
rfcomm_dev_add() puts the new device on rfcomm_dev_list first and only
then registers the tty device and saves it in dev->tty_dev. If that
registration fails, dev->tty_dev is never set at all. The device can be
looked up in the meantime, so an open() of /dev/rfcommN gets through
rfcomm_tty_install() and attaches to it. When that tty is closed again,
rfcomm_dev_shutdown() uses dev->tty_dev without checking it:
Oops: general protection fault, probably for non-canonical address
KASAN: null-ptr-deref in range [0x0000000000000040-0x0000000000000047]
RIP: 0010:rfcomm_dev_shutdown+0x48/0xb0 net/bluetooth/rfcomm/tty.c:131
Call Trace:
tty_port_shutdown+0x1bf/0x220 drivers/tty/tty_port.c:372
tty_port_close+0x4e/0x150 drivers/tty/tty_port.c:705
tty_release+0x359/0x1670 drivers/tty/tty_io.c:1718
__fput+0x418/0xa50 fs/file_table.c:512
rfcomm_dev_destruct() already copes with a NULL dev->tty_dev. Add the
same check to rfcomm_dev_shutdown(), so the tty device is only moved
when it was actually registered. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sock: Serialize dead-device detachment
Rebinding an HCI socket after its controller is unregistered can race
monitor control replay and crash the kernel. hci_sock_bind() clears
hci_pi(sk)->hdev and drops the device reference under only the socket
lock, whereas send_monitor_control_replay() holds hci_sk_list.lock for
reading.
Replay can observe a non-NULL hdev, then bind can clear it and drop the
last reference before create_monitor_ctrl_open() reads hdev->id. This
can cause a NULL pointer dereference if the pointer is reloaded, or a
use-after-free if the old pointer is retained.
The kernel reported:
KASAN: null-ptr-deref in range [0x0000000000000068-0x000000000000006f]
RIP: 0010:create_monitor_ctrl_open+0x579/0x800
Call Trace:
hci_sock_bind+0xd96/0x1190
__sys_bind+0x166/0x200
__x64_sys_bind+0x6d/0xb0
do_syscall_64+0xdd/0x4a0
entry_SYSCALL_64_after_hwframe+0x77/0x7f
The same missing serialization lets hci_send_to_sock() select a socket
for the old device and queue its frame after bind has detached the socket
or installed a new binding.
Take hci_sk_list.lock for writing when clearing the device pointer and
resetting the socket state. This waits for existing replay and delivery
readers to finish before detachment and prevents later readers from
using the old binding. Keep hci_dev_put() outside the critical section
because the final device release can sleep. |
| An unauthenticated buffer overflow vulnerability exists in the underlying operating system of AOS-10 or AOS-8 and could allow an unauthenticated adjacent attacker to conduct a denial of service attack. Successful exploitation could allow an attacker to disrupt the availability of the affected system, with a limited impact to the integrity of the affected component. |
| An unauthenticated Denial-of-Service (DoS) vulnerability exists in the PAPI protocol of AOS-8. Successful exploitation of this vulnerability results in the ability to disrupt the availability of the affected interface. |
| A buffer overflow vulnerability exists in the underlying operating system of AOS that could lead to unauthenticated remote code execution by an unauthenticated remote attacker. Successful exploitation of this vulnerability results in the ability to execute arbitrary code as a privileged user on the underlying operating system. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_core: Serialize ACL scheduling with channel deletion
hci_chan_sent() selects a channel under RCU but drops the read lock before
accessing chan->conn and returning the channel. The ACL and LE schedulers
then use its packet queue and update its transmit counters without any
protection against channel deletion.
After TX selects a channel and releases RCU, a disconnect command timeout
on the separate request workqueue can run hci_conn_failed() and
l2cap_conn_del(). hci_chan_del() can then unlink the channel, complete
synchronize_rcu(), purge its queue and free it before TX resumes. This
causes use-after-free both in hci_chan_sent() and in its callers.
KASAN reported:
BUG: KASAN: slab-use-after-free in hci_chan_sent+0x892/0x9b0
Workqueue: hci0 hci_tx_work
Call Trace:
hci_chan_sent+0x892/0x9b0
hci_tx_work+0x5e6/0xb70
Allocated by task 91:
hci_chan_create+0xe3/0x350
l2cap_conn_add.part.0+0x12/0xa30
l2cap_chan_connect+0x110d/0x1b60
l2cap_sock_connect+0x310/0x530
Freed by task 99:
hci_chan_del+0x11f/0x170
l2cap_conn_del+0x4f1/0x800
l2cap_connect_cfm+0x88c/0xd30
hci_conn_failed+0x150/0x250
hci_abort_conn_sync+0x3e3/0x800
hci_cmd_sync_run+0x7e/0xc0
hci_abort_conn+0x105/0x1f0
disconnect_sync+0x157/0x290
hci_cmd_sync_work+0x13c/0x290
Hold the existing device mutex across channel selection and transmission
in both schedulers to serialize them with channel teardown. Keep timeout
handling outside the critical sections because hci_link_tx_to() acquires
the same mutex. This also permits the transmit path to sleep, unlike
extending the RCU read-side critical section across packet submission. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: typec: tipd: fix uninitialized typec_partner_desc in cd321x_update_work()
cd321x_update_work() passes a stack-allocated typec_partner_desc to
typec_register_partner() after initializing only usb_pd, accessory and
identity.
typec_register_partner() copies attach and deattach from the descriptor
into the partner. With those fields left unset, garbage function pointers
may be stored and later invoked from typec_partner_link_device() when a USB
device is linked to the port. Uninitialized pd_revision and usb_capability
similarly leak stack data through partner sysfs.
Zero-initialize the descriptor so optional callbacks remain NULL and the
remaining fields are zero. |
| In the Linux kernel, the following vulnerability has been resolved:
USB: serial: fix port tear down use-after-free
Some drivers for multiport devices access port driver data from
completion handlers of shared URBs submitted at attach() or first open()
and stopped at disconnect() or last close(), respectively.
A simple NULL check before accessing the driver data makes sure that a
port state container has at least been allocated, but a completion
handler can still race with port tear down.
Reorder the disconnect handling so that ports are not deregistered (and
their driver data freed) until after all ports have been hung up and the
driver disconnect() callback has run so that all I/O has been stopped. |
| Vulnerability in Oracle Essbase (component: Security). The supported version that is affected is 21.8.3.0.0. Easily exploitable vulnerability allows low privileged attacker with network access via HTTP to compromise Oracle Essbase. While the vulnerability is in Oracle Essbase, attacks may significantly impact additional products (scope change). Successful attacks of this vulnerability can result in takeover of Oracle Essbase. CVSS 3.1 Base Score 9.9 (Confidentiality, Integrity and Availability impacts). CVSS Vector: (CVSS:3.1/AV:N/AC:L/PR:L/UI:N/S:C/C:H/I:H/A:H). |
| In the Linux kernel, the following vulnerability has been resolved:
btrfs: restore active device pointers after failed sprout
btrfs_init_new_device() switches latest_dev and possibly s_bdev from the
seed device to the new sprout device before creating the first writable
chunks.
If chunk creation or the subsequent sprout setup fails, the error path
releases the new device without switching those pointers back.
btrfs_show_devname() can then dereference the freed latest_dev and crash.
Restore the active device pointers to the latest seed device before
removing and releasing the failed sprout device. |
| Use after free in Windows Hello allows an authorized attacker to elevate privileges locally. |
| Improper authorization in Windows Virtual Input allows an authorized attacker to elevate privileges locally. |
| Incorrect authorization in Windows Device Install Service allows an authorized attacker to elevate privileges locally. |
| Heap-based buffer overflow in Windows Win32K - GRFX allows an authorized attacker to elevate privileges locally. |
| Heap-based buffer overflow in Windows Direct Composition allows an authorized attacker to elevate privileges locally. |
| Exposure of sensitive system information to an unauthorized control sphere in Windows Shell allows an authorized attacker to disclose information locally. |
| Exposure of sensitive system information to an unauthorized control sphere in Windows Hello allows an authorized attacker to disclose information locally. |
| Out-of-bounds read in Windows Universal Disk Format File System Driver (UDFS) allows an authorized attacker to disclose information locally. |
| Use after free in Windows StateRepository API allows an authorized attacker to elevate privileges locally. |
| In the Linux kernel, the following vulnerability has been resolved:
btrfs: detach failed sprout device from transaction update list
When creating the first metadata chunk for a sprout filesystem,
create_chunk() adds the new device to the transaction dev_update_list
through device->post_commit_list.
If the subsequent system chunk creation fails, btrfs_init_new_device()
aborts the transaction and releases the device while post_commit_list is
still linked. This triggers a warning in btrfs_free_device() and leaves
the transaction list referencing freed memory.
Detach the device while holding chunk_mutex before releasing it. |
