| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A memory corruption vulnerability exists in FFmpeg before 8.1. The RTP encoding process. In the nal_send function in libavformat/rtpenc_h264_hevc.c, a negative size parameter (size=-3) is passed to memcpy when transmitting H.264/HEVC streams via RTP using a crafted input file. This was detected using AddressSanitizer. |
| An out-of-bounds write vulnerability in the SPI host command interface of Semtech's LR11xx transceiver firmware where a crafted SPI host command with an oversized length field can cause the firmware to write up to 254 arbitrary bytes past the bounds of an internal, non-persistent memory buffer. Exploitation requires physical access to the device and logical access to the SPI bus. |
| bincookie is a header-only binarycookies parser. Prior to 0.1.9, bincookie_init_file() in bincookie.h allocates a buffer using the actual .binarycookies file length but trusts the file-controlled num_pages field as the loop bound for byte-swapping page_sizes entries. A crafted file can make the loop read and write beyond the heap allocation, and related unvalidated page sizes and cookie_offsets can drive additional out-of-bounds accesses in page and cookie iteration. Applications that parse an attacker-supplied binarycookies file may crash or suffer heap corruption that can potentially enable code execution. This issue is fixed in version 0.1.9. |
| rapidcsv is a C++ CSV parser library. Prior to 8.99, RemoveColumn, InsertColumn, RemoveRow, InsertRow, and GetColumnNames converted size_t indexes to int before adding them to std::vector iterators. On 64-bit systems, in a CSV matrix dimension containing more than 2^31 elements, an index above INT_MAX could wrap to a negative iterator offset and point before the start of the vector, causing undefined behavior, heap memory corruption, or a crash. Triggering the issue requires an extremely large in-memory document, requiring tens of gigabytes of memory at minimum, so typical CSV documents are not practically affected. This issue is fixed in version 8.99. |
| The NXP MCUX TRNG entropy driver in drivers/entropy/entropy_mcux_trng.c passed the caller's byte count straight to the vendor SDK routine TRNG_GetRandomData(). On i.MX RT5xx and RT6xx parts the SDK compiles its TRNG_SW_HEALTH_TESTS variant, which always copies whole 32-bit words and draws entropy rounded up to a multiple of 128 bytes. Its "caller buffer is full" guard tests dataSize == 0, so a request whose length is not a multiple of four makes dataSize underflow past zero and the SDK keeps writing into the caller's buffer for the entire extraction: a 1-byte request results in 128 bytes written, and any non-word-multiple length overflows by up to 127 bytes.
entropy_get_entropy() is a syscall, and its verifier in drivers/entropy/entropy_handlers.c validates only the requested length via K_SYSCALL_MEMORY_WRITE(). With CONFIG_USERSPACE enabled, an unprivileged user-mode thread that has merely been granted the entropy device can therefore choose both the destination address and a length such as 1, and cause the kernel to write up to 127 bytes beyond the region it proved it owns. On these Cortex-M33 targets there is no MMU, so user partitions and kernel data share one SRAM and the overflow can land in adjacent kernel state. The same defect is reached from kernel mode by any caller requesting a non-word-multiple length, including getentropy() and, in builds where sys_csrand_get()/sys_rand_get() resolve to the hardware generator, sys_rand8_get() and sys_rand16_get().
Impact is memory corruption of up to 127 bytes immediately following the supplied buffer — typically the caller's stack in kernel-mode use, or memory outside the caller's partition when driven through the syscall. The overflow offset is fully determined by the requested length and is therefore deterministic, while the written content is uncontrolled TRNG output; the practical consequences range from crashes and unpredictable state corruption to opportunistic escalation when kernel bookkeeping such as object permission bitmaps is overwritten. The affected devices are those where the MCUX SDK enables TRNG_SW_HEALTH_TESTS (MIMXRT595S, MIMXRT555S, MIMXRT533S, MIMXRT685S, MIMXRT633S), on which the TRNG is the zephyr,entropy chosen node; other SoCs using this driver take the SDK path that clamps the copy size and are unaffected.
The fix routes any unaligned prefix and any sub-word tail through a local bounce word and hands the SDK only word-multiple sizes, so the SDK's word-granular writes can no longer pass the end of the caller's buffer. |
| The user-mode syscall verifiers z_vrfy_fuel_gauge_get_props() and z_vrfy_fuel_gauge_set_props() in drivers/fuel_gauge/fuel_gauge_syscall_handlers.c declared two variable-length arrays, union fuel_gauge_prop_val k_vals[len] and fuel_gauge_prop_t k_props[len], sized directly by the caller-supplied len argument. len is an unvalidated size_t taken straight from the syscall ABI, and the VLAs were allocated before any check at all — including before the K_SYSCALL_DRIVER_FUEL_GAUGE() object-permission check. The subsequent k_usermode_from_copy() calls validated only that the user source buffer was readable; the kernel destination was never bounds-checked, since it was sized by the same attacker-chosen len.
Any thread running in user mode with CONFIG_USERSPACE enabled can invoke fuel_gauge_get_props() or fuel_gauge_set_props() with a large len. This first displaces the supervisor stack pointer by an arbitrary attacker-chosen amount — Zephyr does not build with stack-clash probing, so the displacement itself does not fault, and the nested calls made by the verifier then write frames below the privileged stack. If the caller has been granted access to a fuel-gauge device object, the memcpy inside k_usermode_from_copy() additionally writes len * sizeof(union fuel_gauge_prop_val) bytes of fully attacker-controlled data starting well below the stack base. CONFIG_PRIVILEGED_STACK_SIZE defaults to 1024 bytes, so a len of roughly 170 already exhausts it.
The result is an out-of-bounds write in supervisor mode with attacker-controlled length and, on the permitted path, attacker-controlled content — a break out of the user-mode sandbox into kernel memory, leading to kernel code execution or a system crash. A stack guard region does not contain it, because the copy begins below the guard and walks upward, corrupting unprotected memory before the guard is reached. The fix removes the kernel-side copies entirely and validates the caller's arrays in place with K_SYSCALL_MEMORY_ARRAY_READ() / K_SYSCALL_MEMORY_ARRAY_WRITE(), which also handle the len * size multiplication overflow; this is safe because neither fuel_gauge_prop_t nor union fuel_gauge_prop_val contains embedded pointers. |
| The Goodix GT9xx input driver in drivers/input/input_gt911.c reads the touch point count from the controller's status register and masks it with GT911_TOUCH_POINTS_MSK (0x0F), yielding a value of 0..15. In gt911_process() that value is used directly as the loop bound for filling point_reg[], a stack array sized to CONFIG_INPUT_GT911_MAX_TOUCH_POINTS, whose Kconfig range is 1..5 with a default of 1. No other check constrains the count; the driver relied only on a comment asserting that the controller had been programmed at init to report no more points than configured.
Each loop iteration issues an I2C read of eight bytes straight into point_reg[i], so a controller that reports more points than the array holds causes up to 112 bytes of peer-supplied data to be written past the end of the array, over the stack frame of gt911_process() in the system workqueue thread. Two further loops then read out of bounds from the same array. Triggering it requires control of, or the ability to substitute, the I2C touch controller — plausible on the many supported boards where the GT9xx panel is a pluggable display module or shield rather than an on-PCB part; a spoofed device need only answer the init probes with a supported product ID and a checksum-valid config blob. The same overflow can also occur non-adversarially, with a GT9271-class panel that ignores the driver's touch-count programming and reports up to ten points, or with bus corruption of the single status byte.
The impact is an out-of-bounds stack write with fully attacker-chosen content executing at kernel privilege, i.e. potential control-flow hijack on the host MCU, in addition to out-of-bounds reads and crashes. The attack vector is physical/local hardware access only; there is no network, USB, or syscall path to the defect. The fix clamps the reported count with min() against CONFIG_INPUT_GT911_MAX_TOUCH_POINTS before any array indexing. |
| NXP MQX Classic before 5.0 contains an out-of-bounds write vulnerability in the RTCS UDP recvfrom() implementation. Improper enforcement of the application-supplied receive buffer length may allow a crafted UDP packet to overflow the destination buffer, resulting in memory corruption, or denial of service. |
| Godot Engine through 4.7.2 has a heap out-of-bounds write in the Radiance HDR (.hdr) image decoder (modules/hdr/image_loader_hdr.cpp). The run-length decoding loop expands RLE instructions read from the file into a buffer sized from the image dimensions, without validating that an instruction's repeat/copy count fits the remaining capacity of the row buffer. A crafted .hdr file therefore writes attacker-supplied bytes past the end of the heap allocation, with the overflow length and content controlled by the file. The defect is reached automatically when the product imports a crafted .hdr (e.g., when opening a project containing one), and at runtime in exported projects that load untrusted .hdr images. NOTE: the Supplier's position is that the research has identified "no security issues" because the required attacker access is outside of the current Godot Engine threat model. |
| libTiMidity through 0.2.8 contains a stack out-of-bounds write vulnerability in the SoundFont loader that allows attackers to corrupt stack memory via unchecked generator operators in parse_gen. Attackers can supply a crafted .sf2 file with out-of-range pgen/igen operator values to write chosen 16-bit values near the stack Layer object, causing crashes and stack memory corruption. |
| AdPlug through 2.4 contains a heap-based buffer overflow in CksmPlayer::update() in src/ksm.cpp that writes past the fixed databuf[2048] array without bounds checking. Attackers can supply a crafted .ksm module whose notes share one time slot to overflow the heap player object, causing memory corruption and denial of service. |
| Substance3D - Designer is affected by an out-of-bounds write vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| An issue was discovered in JasPer 1.900.8, 1.900.9, 1.900.10, 1.900.11, 1.900.12, 1.900.13, 1.900.14, 1.900.15, 1.900.16, 1.900.17, 1.900.18, 1.900.19, 1.900.20, 1.900.21, 1.900.22, 1.900.23, 1.900.24, 1.900.25, 1.900.26, 1.900.27, 1.900.28, 1.900.29, 1.900.30, 1.900.31, 2.0.0, 2.0.1, 2.0.2, 2.0.3, 2.0.4, 2.0.5, 2.0.6, 2.0.7, 2.0.8, 2.0.9, 2.0.10, 2.0.11, 2.0.12, 2.0.13, 2.0.14, 2.0.15, 2.0.16. There is a heap-based buffer overflow of size 1 in the function jas_icctxtdesc_input in libjasper/base/jas_icc.c. |
| In all versions of Node.js prior to 6.14.4, 8.11.4 and 10.9.0 when used with UCS-2 encoding (recognized by Node.js under the names `'ucs2'`, `'ucs-2'`, `'utf16le'` and `'utf-16le'`), `Buffer#write()` can be abused to write outside of the bounds of a single `Buffer`. Writes that start from the second-to-last position of a buffer cause a miscalculation of the maximum length of the input bytes to be written. |
| Microsoft Office 2007 SP2, Microsoft Office Word Viewer, Microsoft Office 2010 SP2, Microsoft Office 2013 SP1 and RT SP1, Microsoft Office 2016, and Microsoft Office 2016 Click-to-Run (C2R) allow a remote code execution vulnerability, due to how Office handles objects in memory, aka "Microsoft Office Memory Corruption Vulnerability". This CVE is unique from CVE-2018-0852. |
| A buffer overflow vulnerability in HPE NonStop RDMA SERVICES NSK may cause out-of-bounds memory write, which may result in memory corruption. |
| Out-of-bounds write vulnerability in Citrix Workspace app for Windows.
This issue affects Workspace app for Windows: before 2603.20 CR, before LTSR 2607 Hotfix 1, and before LTSR 2507 CU3 Hotfix 1. |
| A flaw was found in Ghostscript. When Ghostscript renders a crafted PostScript or EPS document, it can bypass the -dSAFER sandbox and execute arbitrary shell commands in the context of the Ghostscript process. The issue chains memory corruption in document parsing with disabling of internal path access controls at runtime. An attacker can deliver the document directly or through formats that delegate rendering to Ghostscript (for example EPS import or print conversion workflows). Successful exploitation can compromise confidentiality, integrity, and availability of data accessible to the process running Ghostscript. |
| A flaw was found in DPDK lib/vhost vhost-crypto. Integer overflow in chain length checks, and missing length checks on the RSA path, can overflow a host buffer in the vhost-crypto backend. |
| A flaw was found in DPDK lib/vhost vhost-crypto. A guest can supply an avail-ring descriptor index that is used without bounds checking, causing an out-of-bounds write in the host vhost-crypto backend. |
